Teach Soap

Hi there
I made a big batch of soaps and I split it to 3 batches and two of them so so soft and the third one so hard and even the LYE screaming get me out of here hhhhhh I want to rebatch the two soft batches clearly need some LYE how can I know how much LYE should I add to them please help me

Thank you

You could rebatch all three together so all of them have the proper amount of lye. I don't know of an accurate way to add more lye water to a batch that doesn't have enough. You cannot add dry lye to a rebatch. The lye would need to be dissolved in more water. You would need to know exactly how much lye you are missing in the soft batches. Sounds like you didn't reach trace before you poured. How much did you superfat total?

_________________
Irena
Closed minds are like faulty parachutes; they refuse to open.

THANK YOU TO YOUR REPLAY
I superfat at%10 and i want to rebatch just the two of them because i don't want mix the color each color of the batchs is different also when I poured them I did reach trace and i mix the soaps butter very very well by my hand and my blender i was very surprised when I i saw the batches after few days

Your reply doesn't really make sense. Even if you measure incorrectly, if the batches were mixed properly, then they would all be the same hardness - or softness.

The only other thing I can think of is whatever may or may not have been added after you split the single large batch into 3 smaller ones. What, if anything was added at this point? Perhaps that is the culprit.