Teach Soap

How do you get the soap out of the tube. I'm glad I only poured one tube. This mold came from Brambleberry's.

_________________
Have a good day,
Linda
www.tuxedo-enterprises.com

you can put the mold in the freezer for about 3 mins. but not much longer if you are using them for embeds. Anne Marie has a video just below the mold on the link you posted. I have also put some of my molds in hot water for about a minute or two to loosen them up.

good luck

Hi Everyone,
I just received the ice tube mold to make the soap on the Soap Queen video using this mold.
I thought I saw the directions for this written out somewhere, but now all I can find is the video.
Has anyone seen the written directions?

Does it work if I make the tubes in advance and save them to use later? I know just spray everything with alcohol before I place them on the layer.

Thanks,
einnoc

_________________
"Soap is to the body what laughter is to the soul!"

Hi, einnoc! I've only found the video, so I don't know about the written directions for the ice tube mold project.

As far as making the tubes in advance, I would think that would work just fine. I've made M&P soap intended to be embeds a day or two in advance before and not had any problems. It's probably best to embed them as soon as possible, but if you need to store them for a bit, I'd wrap them in plastic to keep them fresh. And make sure you spray your layers and embeds liberally with rubbing alcohol!

_________________
- Jenny -
My soapy blog:
Follow me on my

jrose729, Thank you. This is very helpful because I want to make them in advance.
einnoc

_________________
"Soap is to the body what laughter is to the soul!"

You're welcome, einnoc! Good luck with your project - it sounds fun!

_________________
- Jenny -
My soapy blog:
Follow me on my