Teach Soap • View topic

View unanswered posts | View active topics

Board index » Teach Soap Forum » Cold Process Soap

All times are UTC - 8 hours

New soap mold

Moderators: Bramble Girl, soapbuddy, Bramble Momma

Page 1 of 1

[ 3 posts ]

Previous topic | Next topic

Author

Message

wildambrosia

Post subject: New soap mold

Posted: Tue Sep 11, 2012 9:19 am

Joined: Tue Oct 13, 2009 6:17 am
Posts: 52

I just tried out my new 5# wooden soap mold with dividers, from Brambleberry. I poured my soap then put in the dividers. When I went to take the soap out, I found that the dividers hadn't quite reached the bottom even though I pushed them down as much as I could without messing up my swirls. Can anyone give me some tips on this? Should I have made a little less than 5# in order to get the dividers all the way down? I know Anne Marie says this is the best soap mold in the world, so I must have done something wrong!

Top

soapbuddy

Post subject: Re: New soap mold

Posted: Tue Sep 11, 2012 9:52 am

Joined: Mon Jan 14, 2008 11:14 pm
Posts: 24336
Location: Mistress Of Lather

You need to push to dividers all the way down til you feel the bottom. Try making just a smaller batch and push the dividers down fairly hard. It won't mess up your swirls.

_________________
Irena
Closed minds are like faulty parachutes; they refuse to open.

Top

wildambrosia

Post subject: Re: New soap mold

Posted: Wed Sep 12, 2012 7:32 pm

Joined: Tue Oct 13, 2009 6:17 am
Posts: 52

Ok. I'll try it again. The soaps came out ok anyway. Just needed a little trim at the bottoms.
Thanks!

Top

Page 1 of 1

[ 3 posts ]

Board index » Teach Soap Forum » Cold Process Soap

All times are UTC - 8 hours

Who is online

Users browsing this forum: No registered users and 6 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum